Replay-xd XD1080 Manuel d'utilisateur télécharger pdf (Page 7)

1. Find the best mounting location for your Replay XD1080 and check your angles.

Rigid surfaces are ideal for the best video quality. Note: You can use the HDMI out for easy

framing or make a test recording and check it on an iPad/Mac/PC.

2. Flip LowBoy mount upside down and carefully spread, insert Replay XD1080 into

holder with buttons passing through the cut-out.

3. With the Replay XD1080 centered in LowBoy mount, rotate 360º to desired rotation.

4. Slide LowBoy mount into SnapTray until it is fully seated and clicks. The LowBoy mount has

rubber strips to hold your Replay XD1080 from rotating when seated, make sure your rotation

angle is ideal. You can make ne adjustments by sliding the LowBoy in/out of the SnapTray.

5. Attach VHB SnapTray adhesive mount to a clean smooth surface.

The 3M VHB adhesive is not recommended for textured surfaces.

LOWBOY MOUNT

See our full range of mounts at www.Replayxd.com

VHB SnapTray LowBoy Mount

Unlock

Lock

IMPORTANT

Use rubbing alcohol to clean

the mounting surface. Wipe

dry the surface. Apply your

VHB mount to surface. Press

and hold for sixty seconds to

allow adhesive to bond to

the surface. Bond strength

will increase through time.

At room temperature,

wait for at least 24 hours

to achieve 90% bonding

strength, and 72 hours for

100% bonding strength.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Pas de commentaire

Replay-xd XD1080 Manuel d'utilisateur Page 7